How To Use A Circular Saw To Cut Straight?

Just cutting with your cordless or cordless circular saw is easy if you follow the steps below. First, you need to adjust the depth of your cut. To do this, set the length in which the saw blade protrudes from the base of the saw. Always cut your material with the good side down. This will give you a smooth surface when you’re done. When cutting, splinters can occur on the rotating teeth.

Align your saw with the line on the material. When preparing for cutting, you must bring the saw to full speed before coming into contact with your material. Then push the circular saw evenly along the line. Do not press too tight, otherwise, the blade may be pinched. If it comes to a jam, pull back the saw a little and then push it forward more slowly. Click here

When making an angled cut, not only do you adjust the depth of cut, but you also set the base of the saw to the desired pitch. One of the most difficult tasks in a straight line is cross-cutting. Use a Speed ​​Square or Combination Square to make sure you get a straight cut. Remember to wear your protective gear, plan your cut carefully, and carefully position your circular saw.

Basics of the circular saw:

There are some basic principles to optimize the performance of your circular saw and we go through it here. First, make sure you have not just bought a good sheet of paper, but also a good saw. One of the factors that affect the performance of your circular saw is the saw blade you have selected. The carbide blades with their thin kerf are great all-round blades that not only cut quickly but also stay sharp for a long time.

Make sure your eyes are protected before you start sawing. The most common injuries when using a circular saw are eye injuries and cuts. They have always been the best safety goggles you can get. Make sure that you have selected the right blade depth by adjusting the length in which the blade protrudes from your base or shoe. This also limits the amount of kickback you get when cutting.

Always try to hold your circular saw with two hands. This is a powerful machine whose control is paramount to achieve the desired cut. As long as the material you are using does not need to be held, use both hands on the saw. If you do, you will find it easier to make longer cuts easier. If you are cutting a piece of material that is not heavy enough to prevent it from moving when you cut it, pin or nail it firmly to hold it in place when cutting.

How to use a circular saw without a table?

If you do not have a table to secure your material, you will need to clamp it to hold it in place. It is never advisable to hold the material in one hand and use the saw with the other hand, as this can result in serious injury. Even if your material is not properly secured on a table, between saws, or with a screw clamp, you will not be able to make accurate straight cuts.

Kickback of the circular saw:

Using the right blade depth minimizes the amount of kickback when using your circular saw. Setbacks are caused by a few different things, such as incorrect depth, non-saw cuts, and blade binding. And even the best and most experienced users of circular saws can experience that. By standing at the right angle, setting the correct depth and holding the cut-off securely, you can prevent a lot of setbacks.

Circular saw safety:

Circular saws are powerful tools with sharp cutting edges that require the best safety precautions. Distraction or carelessness can cause serious injury, including amputation of fingers and toes, or eye damage. Here are some basic safety precautions you should take when using your circular saw.

Conclusion:

Wear personal protective equipment. These include goggles, face shields and earmuffs like earplugs. Before switching on the circular saw, make sure that the safety guards are in order. Make sure they are clean and free from deposits. If this is not the case, this can lead to a setback. Make sure that the saw blade of your circular saw is sharp.